XBee digital input for digital sensor

Newbie
Post: 1
Bergabung: Sel Jan 14, 2020 2:23 pm

XBee digital input for digital sensor

Postoleh CaitlinEdgar » Sel Jan 14, 2020 3:05 pm

Is possible to use an XBee module to capture the value of a DHT11 digital sensor? If I set the DIO1 to digital input I should receive the value into two bytes, but if the sensor returns more than two bytes how is possible to read the value using an XBee module?

Newbie
Post: 1
Bergabung: Rab Jan 15, 2020 1:40 pm

Re: XBee digital input for digital sensor

Postoleh NoahWillson » Rab Jan 15, 2020 2:01 pm

In order to decode a signal like that, you would need a secondary processor. You might want to take a look at Digi's Programmable XBee modules, which include a Freescale HCS08 processor for additional code that you write. The adafruit page says that it, "requires careful timing to grab the data."

There's sample code on the Digi web page titled, "Developing Timer-Based, Bit-Banged Pulses with the Programmable XBee".

Newbie
Post: 1
Bergabung: Kam Jan 16, 2020 1:40 pm

Re: XBee digital input for digital sensor

Postoleh JakeSchey » Kam Jan 16, 2020 2:49 pm

A blessings on you and all your descendants. It finally makes sense after this post. (And its SO MUCH EASIER for their all users. We are also provide their digital agency malaysia for different digital relevancy.

Newbie
Post: 3
Bergabung: Kam Jan 16, 2020 4:13 pm

Re: XBee digital input for digital sensor

Postoleh JessyWhite » Kam Jan 16, 2020 4:17 pm

Want to have a look at the college paper example? Install SpeedyPaper Adviser and read a pile of templates done by experts. Use them to write your college papers fast.

Kembali ke EVENT



Siapa yang online

Pengguna yang berada di forum ini: Tidak ada pengguna yang terdaftar dan 1 tamu